News

How To Solve The Common Failure Of Intelligent Parking System?

Nowadays many parking lots are equipped with an intelligent parking system, which generally consists of an entrance control machine, an exit control machine, an automatic barrier gate, a sensor coil, a residual display screen, image recognition equipment, system software and a management workstation, among other components.

The following are common failures of the parking system, provided for maintenance reference only.

License plate recognition equipment cannot clearly identify the number

The difficulty of identifying the vehicle license plate area mainly comes from the collected images. Because license plate images vary and are affected by rain, fog, light and other factors, the quality of some images differs. In this case, if the image can be focused clearly, the recognition results can be satisfactory. This places certain requirements on the photosensitive components of the parking system. The camera also needs some configuration improvements, such as adjustments to display resolution and color desktop size.

ANPR1

The intelligent parking system identified the vehicle, but the gate did not rise

Check whether the switch terminal is firmly connected and whether there is a switch signal output at the switch terminal. If there is no switch signal output, the track brake control relay is broken, so replace the control board of the control machine. If the brake still cannot open, check whether the lane brake has failed.

道闸实图

The vehicle passed, but the gates did not lower

Possible reasons are: the ground sensing coil is improperly embedded, or the coil is damaged or broken; the power of the vehicle detector power supply is insufficient (max 250mA), or the induction sensitivity is adjusted improperly (too high or too low); or the interface between the ground detector and the gate controller is disconnected or in poor contact.

The LED display of the parking system is not lit

Check whether the LED power supply is normal and whether the LED chip is normal.

No voice prompt

Check the voice chip and the potentiometer.