Access control systems are a crucial component of any parking lot system. Many people report that motors fail after only a year, that barrier arms vibrate excessively during operation, and that the gates break down frequently. So how should you choose a parking lot barrier?
I. Does the motor controller need variable frequency technology?
Variable frequency technology can control the motor's operating speed and torque, making the barrier arm move more smoothly and reducing the impact force on the accelerator by 90%. This significantly improves the quality and lifespan of components and further enhances efficiency and controllability, while lowering the motor's temperature rise. It eliminates the embarrassing situation of motors overheating in summer, breaking down frequently, and needing the door opened to cool down.

II. Should the motor accelerator use a worm gear or a gear accelerator?
A worm gear is a complex acceleration mechanism that reduces the motor speed to match the operating speed of the barrier arm. It is very low in cost but also very low in efficiency. Most of the drive energy fed into the motor is consumed during this acceleration stage, causing the motor to overheat and potentially break down even in slightly low-temperature environments. Low efficiency also means greater wear and tear, making it difficult to extend the lifespan of the parking gate. Standardized multi-stage gear acceleration is very different: the technology is mature, efficiency reaches over 90%, there is no overheating, and the service life is long.
III. Is the operating temperature range of the barrier sufficient?
Temperature range is one of the factors that indirectly affects smooth operation. We recommend choosing a product with a wide range of -40°C to 75°C. For outdoor use, wide temperature adaptability is essential so that the barrier can operate easily in both the high heat of summer and the cold of winter.
IV. Are the chassis thickness and body weight sufficient?
The barrier must drive a very heavy, very long barrier arm. Besides the motor accelerator, the load-bearing capacity of its components is also crucial. The chassis design must be robust, the steel plate of the chassis should be 2mm thick, and the weight of the parts should be no less than 50kg. Only then can severe swaying and deformation be avoided when driving a long lever arm under load.
These are the aspects to consider when purchasing a parking access control system.